Top transformer cores supplier in China? Transmart transformer manufacturers are an export oriented company with customers located in 40+ countries. We supply high quality tape wound cores in Nanocrystalline, Amorphous and Silicon Steels. Product applications including Common mode chokes ,Hall Effect Current Sensors, Low Voltage and Medium Voltage instrument transformers, Earth Leakage Circuit Breakers ,Reactors, Inductors etc. Read additional details on transformer cores. As we focus on the improvement of the quality, this product has been manufactured with high quality and stable performance. It is of fine workmanship and good quality and is well sold in the domestic market. A positive market response indicates that the product has a good market prospect.
We know that the actual transformer always works in AC state, and the power loss is not only on the resistance of the coil, but also in the iron core magnetized by alternating current. Usually, the power loss in the iron core is called “iron loss”. The iron loss is caused by two reasons, one is “hysteresis loss” and the other is “eddy current loss”. Hysteresis loss is the iron loss caused by the hysteresis phenomenon in the magnetization process of the iron core. The size of this loss is directly proportional to the area surrounded by the hysteresis loop of the material. The hysteresis loop of silicon steel is narrow, and the hysteresis loss of transformer core made of silicon steel is small, which can greatly reduce its heating degree.
The common mode inductor using nanocrystalline core material can well suppress the peak voltage, protect sensitive components, and reduce the motor shaft voltage. Because of the unique characteristics of nanocrystalline core, it has been well used in some high-power system industries. Electric energy meter, power meter, ammeter, electric measuring equipment and other instrument fields. Various power current transformers in power transmission and distribution monitoring system. Leakage protection, relay protection, servo motor protection, fire monitoring, etc Current and voltage data sampling, etc.
Amorphous Core is preferred choice for transformers required low losses at high frequency. We have amorphous c-cores,amorphous ribbon cores,amorphous cut cores,amorphous core transformers . Please find out more about crgo core material. There are 50% and 80% nickel iron materials available, in which we manufactures Mumetal Toroidal core and Mumetal C-core, for the applications in high quality Current Transformers and power supplies industries. See more information at https://www.transmart.net/.
Fe based amorphous alloys are competing with silicon steel in power frequency and medium frequency fields. Compared with silicon steel, iron-based amorphous alloy has the following advantages and disadvantages. The saturated magnetic flux density BS of iron-based amorphous alloy is lower than that of silicon steel. The filling coefficient of Fe based amorphous alloy core is 0.84 ~ 0.86. It shows that Fe based amorphous alloy has better resistance to power waveform distortion than silicon steel.
On the one hand, it can isolate eddy current, and the data is suitable for higher frequencies; On the other hand, due to the gap effect between particles, the data has low permeability and constant permeability; Because the particle size is small, there is basically no skin phenomenon, and the change of permeability with frequency is relatively stable; Moreover, the powder core can be prepared into special-shaped parts of various shapes for different fields; Finally, the damaged strip in industry can be crushed into magnetic powder, and then made into magnetic powder core, which can reduce the loss and improve the use value of data. The magnetoelectric properties of magnetic particle core mainly depend on the permeability of powder material, size and shape of powder, filling coefficient, content of insulating medium, forming pressure and heat treatment process.